As per title.
Changed may sets of pads on VW group vehicles, but is there anything worth knowing about them on the FL2. Like do the clips fly off when you remove the pads, can you get em in without removing the caliper completely etc etc.
Any tips most welcome

Thanks to Lar again there is a frame by frame guide to the fronts, it is a word document in his gallery.
https://www.freel2.com/gallery/displayimag...amp;pos=75

Last edited by ad210358 on 23rd May 2011 7:44 pm. Edited 1 time in total

ad210358 wrote:

Thanks to Lar again there is a frame by frame guide to the fronts, it is a word document in his gallery.
https://www.freel2.com/gallery/displayimage...amp;pos=75

That would have been great but linky not worky 404 not found

A decent Allen key for the front calipers, and mind your knuckles! Also make sure you remove the brake fluid reservoir lid is off. Also a nice strong flat edged item for pushing the piston back in! The clips holding the pads in place can fly off. You don't need to remove the whole caliper!

MVS wrote:

ad210358 wrote:

Thanks to Lar again there is a frame by frame guide to the fronts, it is a word document in his gallery.
https://www.freel2.com/gallery/displayimage...amp;pos=75

That would have been great but linky not worky 404 not found

Working now

https://www.freel2.com/gallery/displayimag...amp;pos=75

Ta muchly

Anything worth noting on the rears as there seem to be a lot of little bits in the box with the pads

Actually they have full Ikea like instructions which are brill

Last edited by MVS on 23rd May 2011 8:15 pm. Edited 1 time in total

There prob new 13mm bolts, there alot easier to do the rear ones! 2x spanners required to undo and tighten!

Ta chaps