daughter complains restricted performance when accelerating hard. my Ap200 showing P006A-00 which clears etc till next event

So felt the short hose down near starter motor -Turbo intercooler hose? and sure enough it was oily.
Part ordered, just love Amazon
Problem is, I have just had hand surgery for carpal tunnel a few days ago so I hope I can do it left handed


While we are on the air system topic, Anyone know if there is a fix/pn for airbox filter screw? 1 of the front screws (inboard) is not tightening up

Sorry can't help with the hose

One fix for the air filer screws is to put the tails of cable clips in the screw holes as fillers

I Like Chips wrote:

Sorry can't help with the hose

One fix for the air filer screws is to put the tails of cable clips in the screw holes as fillers

Well a 15min job someone is having a laugh!
My left hand could really do very little as the space was so cramped. My RH just 13 days after hand surgery and stitches still in was not much better. Bottom clip was OK but releasing the upper clip was soul destroying as I could not see it and my illuminated mirror was not much help either. Once it was out, pretty obvious a large split!

What a complete struggled with the £10 Ama£on next day delivery hose it just wouldn't go on.
In the end had to go local to JSF 4x4 for the correct hose £62! but at least it fitted. I learnt my lesson cheapest is not bestest! Well at least the £10 hose can be returned as not fit for purpose.
Got there in the end but took all afternoon
Test drive was satisfaction up to 70mph as quick as it could touching 4000 revs job done!
A welcome beer and huge smile of satisfaction!

Well earned beer.
Thanks for write up on your success! FL2 XS SD4 Auto 2010 2012-2017 (21k - 91k miles) (MY2011)
FL2 Metropolis SD4 Auto 2014 2017- (16k - 85k+ miles) (MY2015)
Metro in its 12th Year of (Extended) LR Warranty / Full LR Service History
(Expensive, but Trouble/Worry free - hopefully?)

[quote="Kot"]Well a 15min job someone is having a laugh!
My left hand could really do very little as the space was so cramped. My RH just 13 days after hand surgery and stitches still in was not much better. Bottom clip was OK but releasing the upper clip was soul destroying as I could not see it and my illuminated mirror was not much help either. Once it was out, pretty obvious a large split!

/quote]

You should have got your daugter to help - shes probably got smaller and more flexible hands than you. Jules

@Kot :

I think this is the same hose that I had trouble with last October…..connects to throttle housing/ inlet manifold….then to a plastic pipe that goes to the intercooler. I had the same DTC on my AP200 , checked the hoses / connections…..all ok , no oil leaks, no whistle so I sent for new OE MAF & MAP sensors. Fitted MAF first…..easy except car ran worse…..faulty sensor. Changed MAP…..slightly better but still Restricted Performance’. After suggestions on this forum I double-checked this hose…..found slight split…..
Sent for new Gates part….was really tough material….easy to fit in T/housing but difficult on the unsecured plastic hose……once on ok……been great since.
This must be the most common fault on the FL2……a bit of oil & exhaust gas from EGR connection degrades thé rubber……when I wanted to buy a new one thousands had been sold on EBay.
There are lots of posts on this forum concerning this but hard to find them. You did well to ‘sus’it out & repair so quickly, especially with your wrist problem.
Well done FL2 SD4 HSE Lux Auto MY 2012— current
D2 TD5 HSE Man MY 1999 470kmls….gone 2014 ….lovely engine..chassis rotten
D1 300TDI Man MY 1996 56kmls….gone 1999…D2 much better
Wife’s FL1 1.8P MY 2001 32kmls …gone 2007…has Mini since.

Thanks all for feedback, for the record the hose that fitted was also a Gates.

do you know the gates part number ? Jules

Jules: Gates part no. that I bought from Autodoc.fr for turbo hose to throttle valve was 09-0567….
September ‘24….

I was going to post re : I paid €46 for the hose ….inc. postage from Autodoc.fr…..part came from Berlin.. to S. France…….in 4 days…..! FL2 SD4 HSE Lux Auto MY 2012— current
D2 TD5 HSE Man MY 1999 470kmls….gone 2014 ….lovely engine..chassis rotten
D1 300TDI Man MY 1996 56kmls….gone 1999…D2 much better
Wife’s FL1 1.8P MY 2001 32kmls …gone 2007…has Mini since.

thanks

I got my Bilstein rear shocks from Autodoc Jules

jules wrote:

do you know the gates part number ?

Here you go

Many thanks.
I might get one to keep handy just in case. Jules