I just had to replace the dash cam that I fitted in my 2014MY diesel when I bought it in 2016. That camera was wired into F4 and seemed to work fine powering on and off with the car. The new dashcam psu has slightly different fuse bridge connectors and it would be easier to use another empty fuse holder. Can anybody suggest which empty fuses I should use to fit this? TIA

Click image to enlarge

For power which is switched off when the car is not running just bridge from one of these fuses. My dashcams are 0.3 amps each, so 1.5 amps for all 6 cameras. Unscrew the A column trim panel. The screw is covered by the airbag logo which pops off with a butter knife or similar. The star screw from memory is a T40. So you can run are cable, & keep the cable behind the airbag. The rubber around the door just pulls off & then push in back on after.

F52 Cigar lighter (front)
F55 Auxillary sock (rear console)
F63 Auxiliary socket (luggage compartment)

Fuse box teardown:
https://www.freel2.com/forum/topic34833.html Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18