Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Tips & Tricks > Any tips/tricks on how to cure closed sunroof wind noise?
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Mudpuggler



Member Since: 21 Aug 2017
Location: Scotland
Posts: 29

United Kingdom 2008 Freelander 2 TD4 HSE Manual Santorini Black
Any tips/tricks on how to cure closed sunroof wind noise?

Hi all,

I'm a new 2008 HSE owner.

Sunroof is generating noise fully closed at above 60mph.

Tilt and it goes away, shut it and noise instantly comes back. I've searched for 4 days on the internet with no method or cure!

Looks 'almost' flush with rear sunroof and seals seem fine. My apologies if this is a banal question but it is distracting me from the overall driving experience.

Cheers.

Post #329651 21st Aug 2017 7:33 pm
View user's profile Send private message View poster's gallery Reply with quote
Lunar-Rover



Member Since: 15 Jun 2017
Location: Bolton Lancashire
Posts: 109

England 2007 Freelander 2 TD4 SE Manual Sumatra Black

Many many years ago I used to fit (1978) Hollandia electric sunroofs in top end vehicles of the time. There used to be an adjustment at the rear of the roof panel to lift up/down not sure if the L/R roofs have, when I get chance I will have a look at mine. But in the immediate term, spray down the side/front and rear channels and if there is a seal on the panel, that too with good ole WD40 or a decent Silicone spray. The seals tend to dry up over time which causes the panel to not seat correctly, if you have access to an airline, blow all the crap out of the channels and wipe clean then spray. REME .. Rough Engineering Made Easy

Post #329699 22nd Aug 2017 4:00 pm
View user's profile Send private message View poster's gallery Reply with quote
Mudpuggler



Member Since: 21 Aug 2017
Location: Scotland
Posts: 29

United Kingdom 2008 Freelander 2 TD4 HSE Manual Santorini Black

Thanks for the reply.

Yesterday I wiped all the seals with Autoglym rubber and vinyl restorer and cleaned the channels, they were not very dirty to be honest. That has made no difference.

Today I taped up the rear shut line were the two glass panels meet. No difference. I then did the front and sides, also with no difference. Note, I did one side at a time and not altogether.

Do you mean there is a manual way of tilting the pane up and down? eg with a screwdriver adjustment?

This is the first car I've owned with a sunroof. The dealer I got it from 'promised' to get it sorted before I picked it up but as per usual, I have been let down.

Thanks for the advice, if you have any other suggestions then let me know.

Cheers.

Post #329704 22nd Aug 2017 5:33 pm
View user's profile Send private message View poster's gallery Reply with quote
Lunar-Rover



Member Since: 15 Jun 2017
Location: Bolton Lancashire
Posts: 109

England 2007 Freelander 2 TD4 SE Manual Sumatra Black

I have still not been out to look at mine however, been having a think of how I used to adjust the panel and to lift the rear up it was on forwards tilt, this allows access to the adjustment at the rear sides of the panel to allow up/down movement. This is all of the top of my head thinking of the logical way that these things work and without looking at mine, also now I think of it, I have not seen a manual method of closing the roof in case of motor failure or electric fault. At the rear of the type I fitted was access through the headlining to a small ratchet which closed the roof. REME .. Rough Engineering Made Easy

Post #329710 22nd Aug 2017 6:23 pm
View user's profile Send private message View poster's gallery Reply with quote
thabogrobler



Member Since: 16 Sep 2014
Location: Pretoria
Posts: 51

South Africa 2007 Freelander 2 TD4 S Auto Baltic Blue

Reviving an old thread - I had the same and sprayed the runners with some kube and all was good.

Post #338385 1st Jan 2018 8:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Mudpuggler



Member Since: 21 Aug 2017
Location: Scotland
Posts: 29

United Kingdom 2008 Freelander 2 TD4 HSE Manual Santorini Black

Will have to give this a go at some point.

do you have to dismantle any part of the sunroof to do this?

Post #339517 15th Jan 2018 3:34 pm
View user's profile Send private message View poster's gallery Reply with quote
superg28



Member Since: 20 Jan 2019
Location: Johannesburg
Posts: 1

South Africa 2012 Freelander 2 SD4 HSE Auto Fuji White

Any solutions found yet? Manual adjustment or lube that works?
Tried some auto adjustments by holding down the ‘close’ button but without any luck

Post #364799 27th Jan 2019 6:12 pm
View user's profile Send private message View poster's gallery Reply with quote
thabogrobler



Member Since: 16 Sep 2014
Location: Pretoria
Posts: 51

South Africa 2007 Freelander 2 TD4 S Auto Baltic Blue

I sprayed the runners with WD40.

I since found some graphite powder that I will try next time.

Post #364806 27th Jan 2019 7:52 pm
View user's profile Send private message View poster's gallery Reply with quote
Mudpuggler



Member Since: 21 Aug 2017
Location: Scotland
Posts: 29

United Kingdom 2008 Freelander 2 TD4 HSE Manual Santorini Black

I've not found a suitable solution to this annoying problem, except having music a bit louder.

Post #364852 28th Jan 2019 1:01 pm
View user's profile Send private message View poster's gallery Reply with quote
thabogrobler



Member Since: 16 Sep 2014
Location: Pretoria
Posts: 51

South Africa 2007 Freelander 2 TD4 S Auto Baltic Blue

I lubed the runners with graphite powder and it works a charm!

Post #413531 18th Oct 2021 10:57 am
View user's profile Send private message View poster's gallery Reply with quote
Boxbrownie



Member Since: 17 Mar 2019
Location: Looe
Posts: 2053

United Kingdom 2007 Freelander 2 i6 HSE Auto Stornoway Grey

When solid sunroof first launched the usual setting up regime was to have the rear surface of the sunroof about 1/8th inch (that’s how long ago it was) above the level of the metal roof panel surface.

Edit : the front two surfaces should be dead level. Regards

David

Lovely i6 has now gone, but not me......

Please let me know if anything in my post offends you, as I may wish to offend you again......

Post #413540 18th Oct 2021 4:45 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site