Does anyone know if the Evoque differential and Haldex from the early Evoques (2012-2014) was exactly the same as the late model Freelanders?

This is what I seem to gather by looking at the pictures.

Thank you!

Last edited by Freely2 on 21st May 2019 11:16 am. Edited 1 time in total

You could try PMing or emailing Austin at Bell Engineering

http://www.bellengineering.co.uk/ Tangiers Orange - gone, missing her
Replaced by Ewok what a mistake - now a happy Disco Sport owner

Hi, Does anyone know the filter kit number for 2013 model. I think this is the final version of Haldex for Freelander?

FL2 from 2008 onwards and all Evoque up to MY16 (don't quote me on exact change date) were fitted with Gen 4 Haldex

if you want confirmation or more info for part numbers etc then go http://www.bellengineering.co.uk/?gclid=EA...gIGqPD_BwE

OLOSTEVE wrote:

Hi, Does anyone know the filter kit number for 2013 model. I think this is the final version of Haldex for Freelander?

Thank you for the response to my request for part number.
As I have 2013 model, my, Haldex is the, "Generation 4", as fitted to the Evoke.
Part no. LRO32298. for filter.
I now need the, Stat oil, SL01-301 0.65 litres, anyone know where the best place to get oil, but more impoartant thing I need to know is do you still need to remove 70 mil once topped up to filler?

Just get the whole kit from Austen at Bell Engneering

https://www.ravenol-direct.uk/ravenol-awd-h-fluid.html

VegaDude wrote:

Just get the whole kit from Austen at Bell Engneering

Or.... When he back open (10th June) book it in like I'm going to


Seriously though he the man to ask  If it wasn't so bad it'd be funny.

🐑
Freelander 2 HSE auto 2014 ( Florrie ) ..... Try again.
Freelander 2 GS 2012...... Gone.

Yup! Phoned this morning to order the complete kit, and as you say closed till, June 10th

Ordered service kit today. Useful advice was to remove unit to empty and change filter. No need to remove 70ml last top up after running for 5 minutes. Top Bloke at Bell Engineering

Last edited by OLOSTEVE on 17th Jun 2019 7:26 pm. Edited 1 time in total

Please explain the not removing the
70ml?
Ta

If you look on, Haines Manual, they say you need to remove, 70ml of fluid after you have run engine for 5 minutes on tick over and have topped up to overflow. This didn’t make a lot of sense to me and the top man at, Bell, said you didn’t need to do that. I think I would always take advice from the bloke on the shop floor rather than someone in an office putting out miss information, as, “Donald”, would say.