Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > In Car Electronics > in car camera
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Vince



Member Since: 19 Feb 2014
Location: Durham
Posts: 44

United Kingdom 2014 Freelander 2 TD4 GS Manual Rimini Red
in car camera

Hi all,

I took my night hawk camera out of my previous car when I bought the freelander. My previous was clearly much easier to take to bits than the freelander!

I used the connections on the back of the cigarette lighter to power it in the past but can't quite figure out how to get to it or route the cables. Any suggestions or bright ideas?

Just needs a standard 12v and preferably on with ignition...

Cheers
Paul.

Post #219462 13th Mar 2014 9:30 pm
View user's profile Send private message View poster's gallery Reply with quote
ad210358



Member Since: 12 Oct 2008
Location: Here and There
Posts: 7464

England 

Fuse F5 is ignition live, located in the Fuse Box behind the Glove Box.

Post #219467 13th Mar 2014 9:50 pm
View user's profile Send private message View poster's gallery Reply with quote
3disco



Member Since: 18 Apr 2014
Location: devon
Posts: 659

United Kingdom 

I plugged my night hawk into the aux socket in the centre consol, switches off a short while after the ignition is switched off.

Post #223689 1st May 2014 10:17 pm
View user's profile Send private message View poster's gallery Reply with quote
Wing



Member Since: 26 May 2010
Location: Manchestor
Posts: 309

England 2013 Freelander 2 SD4 HSE Lux Auto Santorini Black

I have my Blackvue camera located directly behind the RVM.
The cable is routed between the headlining and windscreen, totally out of sight and down the passenger side 'A' post, hidden behind the rubber sleeve. From there it runs between the carpet and kick plate along the length of the front passenger door, before it passes between a gap in the carpet, under the passenger seat and up into the gap between the passenger seat and centre console, then disappearing into the top of the sliding lid of the centre console.
Ideally I would like it to be totally out of sight and considered drilling a small hole in the bottom of the console to feed the cable through, but reconsidered as I intend to route it through to the boot when I find a permanent live. You can only see an inch of cable as it bends over the top of the console and disappears into the sliding cover "which still closes" before being plugged into one of the power sockets.
No tools req , nothing to remove and job done in 10 minutes Thumbs Up

Post #223771 2nd May 2014 4:13 pm
View user's profile Send private message View poster's gallery Reply with quote
ad210358



Member Since: 12 Oct 2008
Location: Here and There
Posts: 7464

England 

Mines almost routed the same way, RVM, Headlining, N/S A Post, pull of the Door Seal, down behind the Glove Box, Piggy Back Fuse in the Fuse Box behind the Glove Box.

Post #223776 2nd May 2014 5:24 pm
View user's profile Send private message View poster's gallery Reply with quote
Vince



Member Since: 19 Feb 2014
Location: Durham
Posts: 44

United Kingdom 2014 Freelander 2 TD4 GS Manual Rimini Red

cheers everyone. I got the cable routed easily and piggy backed the front cigar lighter fuse (cant remember the number).

I'm not too fussed about hiding the camera, infact i would rather people knew it was there - plus it has a big blue led on the front!

Post #224244 8th May 2014 7:36 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT + 1 Hour

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site