Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com
Home > Maintenance & Modifications > EGR Blanking - ALL HERE
EGR Blank or Not To EGR Blacnk that is the question?
Blank EGR
81%
 81%  [62]
Leave EGR as Standard
18%
 18%  [14]
Total Votes: 76

Post Reply  Down to end
Page 9 of 15 <123 ... 8910 ... 131415>
Print this entire topic · 
dnaltan



Member Since: 10 Nov 2016
Location: UK
Posts: 14

Steven.T wrote:
Hi Sandy, It's quite straightforward to do if you are handy with a spanner...
Remove engine cover, slacken off pipe retaining bolt, slacken off two bolts on end of pipe, slide plate into place, retighten everything in reverse.
This is where I got it from, theres a few pics there aswell shows you where it goes:
http://www.ebay.co.uk/itm/111585376243?_tr....S1.R1.TR3


Interesting - did you go for the one with the hole in it?!

In his ad it says "Blocking the EGR system on these engines completely will put on the engine management light/warning on, unless the egr valve is mapped out. I also list it with a hole in (111585366725), so that the warning light should not come on".

Is there any downside to doing this?
Post #311329 17th Nov 2016 8:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Steven.T



Member Since: 08 Nov 2015
Location: Stockton-On-Tees
Posts: 219
United Kingdom 2009 Freelander 2 TD4_e GS Manual Lago Grey

I fitted the one without a hole. As far as I know...
If its pre my10 then you can fit one without a hole, and not get any faults etc ( I haven't had any errors)
If its my11 or after then the one without a hole will cause a fault, so the hole is needed to let a bit through.
I think!?
Post #311347 17th Nov 2016 10:42 pm
View user's profile Send private message View poster's gallery Reply with quote
sergio977



Member Since: 08 Jan 2016
Location: Italy
Posts: 128
Italy 2007 Freelander 2 TD4 S Manual Orkney Grey

westville wrote:
Blanking EGR is not always straightforward - depends on the engine, year and even model car uyou have - do some research before you jump in - there are plenty of posts on here and other forums


I'm not sure of that: from my experiences, I never seen a DTCs or Engine lights caused by an EGR blank( without hole, 100% blank): even on newer model ( MY12/MY13) or also on the 2.2 SD4 Evoque.

What I seen, is that the impossibility to blank post 2010 Fl2 without DTCs is a WebMith Very Happy
Post #311365 18th Nov 2016 9:04 am
View user's profile Send private message View poster's gallery Reply with quote
rnlisg



Member Since: 10 Oct 2016
Location: romney marsh kent
Posts: 400
England 2013 Freelander 2 SD4 HSE Auto Santorini Black

Steven.T wrote:
Hi Sandy, It's quite straightforward to do if you are handy with a spanner...
Remove engine cover, slacken off pipe retaining bolt, slacken off two bolts on end of pipe, slide plate into place, retighten everything in reverse.
This is where I got it from, theres a few pics there aswell shows you where it goes:
http://www.ebay.co.uk/itm/111585376243?_tr....S1.R1.TR3

Thumbs Up
Post #311370 18th Nov 2016 10:18 am
View user's profile Send private message View poster's gallery Reply with quote
Mega1879



Member Since: 31 Jul 2016
Location: Doncaster
Posts: 13
United Kingdom 

Hi there, my car a 2007 hse was going into limp mode when pulling away at a junction fast or giving it a bit on the motorway!! Fault code showing a overboost p0234. Fitted a £3.95 blanking plate off eBay and its not done it since!! Drives spot on Thumbs Up
Post #311372 18th Nov 2016 10:28 am
View user's profile Send private message View poster's gallery Reply with quote
ianfish



Member Since: 08 Mar 2016
Location: north devon
Posts: 70
United Kingdom 2013 Freelander 2 TD4 GS Auto Santorini Black

sergio977 wrote:
westville wrote:
Blanking EGR is not always straightforward - depends on the engine, year and even model car uyou have - do some research before you jump in - there are plenty of posts on here and other forums


I'm not sure of that: from my experiences, I never seen a DTCs or Engine lights caused by an EGR blank( without hole, 100% blank): even on newer model ( MY12/MY13) or also on the 2.2 SD4 Evoque.

What I seen, is that the impossibility to blank post 2010 Fl2 without DTCs is a WebMith Very Happy
I don't think it can be done on the facelift models(MY11 onwards) is that correct? i did have a problem on my MY13 -reduced power mode while towing the caravan to be exchanged in Dorset ! I have 2 years free Landrover Breakdown and they came out very promptly, said "it's the EGR sticking. I asked if it could be blanked off and he said no, it's a really hard job because it was at the back of the engine now not at the front. Local dealer repaired under warranty. Interesting towing back to Devon on reduced power though! Sport/ command shift all the way! Just a bit slow up the hills! MY 2013 SD GS Auto
Post #311379 18th Nov 2016 11:29 am
View user's profile Send private message View poster's gallery Reply with quote
sergio977



Member Since: 08 Jan 2016
Location: Italy
Posts: 128
Italy 2007 Freelander 2 TD4 S Manual Orkney Grey

Hi ianfish, I blanked ( with the cheap Ebay plates, as explained on Steven.T previous posts ) the EGR of:

-my FL2 ( my2007)
-my friend FL2 ( my2012)
-my friend FL2 ( my2013)
-my neigbour Evoque 2.2 ( my2013)



without any issues (all these cars are DPF equipped, and without modifications) Thumbs Up

If you had the problem when towing, maybe the issue wasn't due to EGR... Confused
Post #311387 18th Nov 2016 12:14 pm
View user's profile Send private message View poster's gallery Reply with quote
ianfish



Member Since: 08 Mar 2016
Location: north devon
Posts: 70
United Kingdom 2013 Freelander 2 TD4 GS Auto Santorini Black

that's interesting, I heard that it was at the back of the engine and difficult to get at.

No it wasn't anything to do with towing , just happened then , fault code was EGR valve sticking, replaced, fine now. MY 2013 SD GS Auto
Post #311457 19th Nov 2016 12:30 pm
View user's profile Send private message View poster's gallery Reply with quote
Mav71



Member Since: 15 Nov 2008
Location: Leicester
Posts: 2575
United Kingdom 2007 Freelander 2 TD4 HSE Manual Stornoway Grey

You can fit it to the facelift car, but they make no difference. Freelander 2 HSE Lux 2013MY - Barolo Black with Ivory Leather. Alpine DVD - Privacy -Evoque 20" Dynamic Wheels and more to come.........
Post #312511 2nd Dec 2016 5:21 pm
View user's profile Send private message View poster's gallery Reply with quote
Past master



Member Since: 30 Jun 2010
Location: Isle of Ely
Posts: 2710
United Kingdom 

It should make a noticeable difference if the EGR valve is stuck open. Otherwise no, you won't see a difference. Ex AA Series III LWB Safari - Gone
300TDi Disco (bought new - terrible car) sent back after 18 months
Freelander 1 Estate - leased, given back at end of lease
200TDi Disco (bought from a mate with 100,000 on the clock) - Gone
Disco 2 TD5 - sold and exported to France
FR2 TD4 GS - Gone
FR2 SD4 HSE - Now changed for a DS
New model ex-demo Evoque S 180 in white
Unable to order a new DS, so gave up. Now have a Volvo S90 Recharge.
Post #312518 2nd Dec 2016 7:21 pm
View user's profile Send private message View poster's gallery Reply with quote
harry8080



Member Since: 07 Dec 2016
Location: midlands
Posts: 14
United Kingdom 2008 Freelander 2 TD4 GS Manual Barolo Black

Fitted a blanking plate today to my 2008 model and noticed an immediate difference already. Fitted these to all my diesels so far and have had no problems yet. Most systems have a recirculating device purely for emissions and quick warm up for city smog control.
Post #312808 7th Dec 2016 10:38 pm
View user's profile Send private message View poster's gallery Reply with quote
harry8080



Member Since: 07 Dec 2016
Location: midlands
Posts: 14
United Kingdom 2008 Freelander 2 TD4 GS Manual Barolo Black

2700 miles later and what a nice car it is to drive, fuel consumption is now rock steady at 36mpg, I am quite ham fisted at driving the car so do not drive economically at all. Overall pleased with with this simple modification
r
Post #314211 30th Dec 2016 10:37 pm
View user's profile Send private message View poster's gallery Reply with quote
captin



Member Since: 19 Oct 2016
Location: rochester
Posts: 110
United Kingdom 2007 Freelander 2 TD4 HSE Manual Zermatt Silver

same as harry8080 well 35mpg to be exact and never seen any smoke Very Happy
Post #314219 31st Dec 2016 4:57 am
View user's profile Send private message View poster's gallery Reply with quote
Bobbyg



Member Since: 04 Dec 2016
Location: Yorkshire
Posts: 214
England 2007 Freelander 2 TD4 S Manual Indus Silver

Hi there are two versions on eBay with and without a hole,from the same supplier .bertye1958.which one have we fitted.
Post #314346 2nd Jan 2017 6:02 pm
View user's profile Send private message View poster's gallery Reply with quote
harry8080



Member Since: 07 Dec 2016
Location: midlands
Posts: 14
United Kingdom 2008 Freelander 2 TD4 GS Manual Barolo Black

The version without the hole.
Post #314351 2nd Jan 2017 6:50 pm
View user's profile Send private message View poster's gallery Reply with quote
Post Reply  Back to top
Page 9 of 15 <123 ... 8910 ... 131415>
All times are GMT + 1 Hour

Jump to  
<  Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site