Ok. Super noob electrical question.

I have my piggy back fuse which will be used for a dashcam. I intend on wiring a cig socket onto this to then power the dashcam or anytjing else.

The fuse has a wire coming from it with some form of crimp. Do i simply put the bare power cable from the cig socket in and crimp.or should i put a ferrule on the cable and then insert that?


 Learned to drive in 2011.
Bought a Micra - great little car
"Upgraded" to Kia Sportage - hated it
Proper upgrade to FL2 TD4 GS 60 reg Facelift - tailgate paint issues, fuel gauge rewire, transfer box failure at 36k miles, clutch at 60k
Reconditioned diff at 70k ish
Sold at 84k and now on a DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental

Just bare about 4mm of cable and push it in, then Crimp it with one of these.

https://www.tlc-direct.co.uk/Products/DR21...oCb1Hw_wcB p****d off with a Digital Keyboard Warrior

Perfect. Thabks. Learned to drive in 2011.
Bought a Micra - great little car
"Upgraded" to Kia Sportage - hated it
Proper upgrade to FL2 TD4 GS 60 reg Facelift - tailgate paint issues, fuel gauge rewire, transfer box failure at 36k miles, clutch at 60k
Reconditioned diff at 70k ish
Sold at 84k and now on a DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental