Fuel cap will not open…fuse ok ….assume it’s the solenoid!…can someone tell me where it’s located and how to access it…are they easy to fit…many thanks

I can find no information on this (searched internet and JLR workshop manual) . I guess you need to remove the internal trim panel for a start. (nope its via the wheelarch) Jules

Last edited by jules on 3rd Jul 2025 2:38 pm. Edited 2 times in total

Any help
https://www.freel2.com/forum/topic22575.ht...p;start=15

Well done Kot - its all there + pics

I quote
"If the actuator has failed in the locked condition you need to remove the rear RH wheel and wheel arch lining, unplug the connector and remove the actuator, this allows the flap to open.
...part number LR006363 ... land rover technical bulletin LTB00292"


So its all done via the wheelarch. Jules

Bloody hell…thanks Jules

While you have the wheel arch liner off, you can give everything a good clean while at it.

While at it do the other side as well. Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18