hello folks 2010 HSE auto.
Fault showing up as oxygen sensor not working properly.
1, could this cause a vibration/rumble from time to time.?
2. How important is this and should i replace it ASAP.
If so, how difficult to change?
Engine/ autobox all seem to be running ok.
Help please Jim A
Fl2 HSE 2010 auto
Disco 2Td5 auto 2002 gone
Disci 1 300Tdi auto 1996 gone

bit more searching says diesels don,t have oxygen sensors, so why is it coming up om my Autel.
Landrovers do teach you something every day. Jim A
Fl2 HSE 2010 auto
Disco 2Td5 auto 2002 gone
Disci 1 300Tdi auto 1996 gone

If the O2 sensor is giving a code, then it's outside the ECM's ability to compensate for age.
Replacement is the only cure, however it does depend on the exact code you're getting, as to what the issue is.
Yes diesels do have O2 sensors, it's all part of the emissions system.  2009 Rimini Red SE TD4. Soon to be sold.
Hyundai Ionic 5 Ultimate on order.
Gone. 2006 Tonga Green i6 HSE.

janderson41 wrote:

bit more searching says diesels don,t have oxygen sensors, so why is it coming up om my Autel.
Landrovers do teach you something every day.

I removed the plenum panel and the ECU to get at the O2 sensor. You will likely need heat to remove I did.

I cut the wire off so I could get a six sided long socket on it from above with a couple of extension bars. While you are there you may as well change the first Exhaust Gas Temperature Sensor.

I know some have done it from below but I couldn't even after removing the pipework from the Turbo to the Intercooler.

It will make you curse.

Last edited by I Like Chips on 2nd Nov 2022 1:40 pm. Edited 1 time in total

Thank you all for the free and excellent advice.
Next query, would the faulty sensor affect the running of the car?
There does not seem any problems with starting, running etc.
Anyway, will rectify this soonest. Jim A
Fl2 HSE 2010 auto
Disco 2Td5 auto 2002 gone
Disci 1 300Tdi auto 1996 gone

Chips, I now have to get any major work done at my local garage.
Car going in Thursday to try and find source of vibration.
Will explain this to them.. More LR problems
Thank you Jim A
Fl2 HSE 2010 auto
Disco 2Td5 auto 2002 gone
Disci 1 300Tdi auto 1996 gone

A garage will use an O2 sensor socket, which has a cutout designed to accommodate the sensor wiring.
Mine wasn't that tight, but with the other bodged stuff I found, it had probably been removed and not tightened properly.

Access to the O2 is either from below, or above, but it's tight without stripping out at least some of the vehicle.

I've ringed it in red in this picture, but as the head is removed, you can get an idea of what it looks like, and how far down the back of the engine it is.

Click image to enlarge

I replaced 2 O2 sensors on my FiL's Corsa the one on the exhaust manifild was an absolute sod.

@Nodge why is cylinder 2 a different colour to the other 3 ? leaking head gasket ? Jules

jules wrote:

@Nodge why is cylinder 2 a different colour to the other 3 ? leaking head gasket ?

Cylinder 2 is shiny because I glaze busted the bore before fitting a replacement piston. The piston in there had been mashed by a nut that a previous (I won't call him a mechanic ) had dropped into the intake.

The piston looked like this.

Click image to enlarge

 2009 Rimini Red SE TD4. Soon to be sold.
Hyundai Ionic 5 Ultimate on order.
Gone. 2006 Tonga Green i6 HSE.

This code only showed up this week.
As said, going in tomorrow to try and find vibration problem.
Can some say how safe to drive at moment. Jim A
Fl2 HSE 2010 auto
Disco 2Td5 auto 2002 gone
Disci 1 300Tdi auto 1996 gone

No problem driving it, if you are getting it fixed

latest-- vibration cured by replacing OS brake caliper.
Had cleared faults and no more showings of sensor fault.
Have tried again twice and today after a 25 mile run. Still no fault showing.
Good to drive without vibration/judder.
Will monitor fault weekly.
Thankd for all the suugestions Jim A
Fl2 HSE 2010 auto
Disco 2Td5 auto 2002 gone
Disci 1 300Tdi auto 1996 gone