Hey there
I need solution freelander 2002
VIN #SALLNABA72A367678
Motorola ECU with CAN bus
nnn 10071 inside EEPROM 93C66 chips
Main problem was lost all key I add key
pcf7935 using Range Rover Freelander
EWS3 key Programing by Ak90 & Ikeyclone
After programming OD46J Engine crank
Start for 2sec then stop,,fault code
(engine control module random code
XOR error)
But I did not understand, the red warring light was not flash(dead) even key Removed,to start car properly this red light must flash but not flash I check the wiring red light
LED from CCU(Central control unit)
Connecter pin C0592F ,,ok because the
Red wiring light out from CCU,
NOT from ECU nor from EWS3,,,
So CCU is the problem I check all
Power source and ground for CCU
every thing ok ,,,,
Why abesent immobilizer red light flashing by any means I won't to
Start the car is possible

Regards

New member joined today, say hello?

'immo'

Using proper words when people use the search function makes the topic useful for future reference. Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18

Here are the results of a search under 'immobilizer':
https://www.freel2.com/forum/search.php?se...rch_time=0

Personally, I have very little knowledge re any Freelander 2 model but my own.