Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Technical > P245 Fault on 2011 HSE TD4
Post Reply  Down to end
Page 1 of 2 12>
Print this entire topic · 
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black
P245 Fault on 2011 HSE TD4

Hi,

Just wondered if anyone can advise me whats going on with my Freelander 2, my local garage are scratching their heads after 2 visits there and now its got worse. All started about 3 weeks ago when an engine management light appeared on the dash and no impact on performance. Plugged in a cheap odb reader and it showed code p245a which i thought 'egr valve/cooler', took a while to get a booking from my garage and they had a look and said 'not sure, too many codes to decipher cause, so we have removed them all, take it for a drive and bring it back if eml comes back on', ok a day later it reappeared so took it back again, they said 'could be dpf or egr or glow plugs or glow plug module according to their code reader'. On investigation they found one glow plug melted at the end, fine they changed it and gave me car back and a couple of days later eml on again still with same p245a code. I will now get to today, went outside to get something out of the car and i thought i will read codes again and check for any pending or other ones after a short drive but car wouldn't start. Battery output 7.8 volts and code p245a still there and constant electrical whining type noise like a circuit is constantly powered and key stuck in ignition. Currently charging the battery to see if that will release key and stop noise. Anyone got any ideas whats going on, could it be faulty glow plug module causing glow plug melt, p245 error and now constant energised system circuit? Will it need a Land Rover specialist? Or is there something i can suggest they do when they get the car tomorrow?

JB

Post #391831 31st May 2020 2:47 pm
View user's profile Send private message View poster's gallery Reply with quote
MotionInc



Member Since: 17 Jun 2019
Location: North America
Posts: 1285

Canada 2008 LR2 i6 SE Auto Tambora Flame

I have never owner a diesel but I searched the code you posted on the forum and here are the results:
https://www.freel2.com/forum/search.php?se...rch_time=0

Is this the only code thrown?

Post #391832 31st May 2020 3:17 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

Yes only code and up to now no impact on performance. Just now added battery issue if its related.

Post #391833 31st May 2020 3:23 pm
View user's profile Send private message View poster's gallery Reply with quote
MotionInc



Member Since: 17 Jun 2019
Location: North America
Posts: 1285

Canada 2008 LR2 i6 SE Auto Tambora Flame

Yeah, a battery that low will likely need replacing or at the very least, reconditioning. Sadly, it will only complicate matters with these vehicles.

Post #391834 31st May 2020 3:33 pm
View user's profile Send private message View poster's gallery Reply with quote
TooBlue



Member Since: 30 Oct 2019
Location: Midlands
Posts: 261

United Kingdom 

Have a read here https://www.obd-codes.com/p245a

You need to replace that battery before anything else though.

Post #391838 31st May 2020 3:59 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

Currently disconnected battery and charging overnight. See if it starts in the morning. Would a specialist be best to diagnose cause of p245a fault?

Post #391840 31st May 2020 4:05 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

Could a faulty glow plug module cause all these issues inc battery discharged or has a faulty battery caused it all. But what symtoms would there have been if the battery was deteriorating?

Post #391842 31st May 2020 5:17 pm
View user's profile Send private message View poster's gallery Reply with quote
Wonderdust



Member Since: 23 Mar 2020
Location: Bucks
Posts: 137

United Kingdom 2013 Freelander 2 SD4 HSE Lux Auto Santorini Black

Might be wrong but I honestly don't think you will get that battery back from such a low voltage. It might start in the morning but as for holding a charge that's another matter. Good luck.

Post #391845 31st May 2020 5:31 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

Just charged it for about 4 hours and multimeter says output is 14.8v, putting it on maintenance charge overnight. I bet its that glow plug module knackering everything up.

Post #391847 31st May 2020 5:50 pm
View user's profile Send private message View poster's gallery Reply with quote
BossBob



Member Since: 30 Sep 2010
Location: Bristol
Posts: 1248

England 2007 Freelander 2 TD4 GS Manual Baltic Blue

A high pitched whine after shutting down the engine is normally diagnosed as a problem with the throttle valve.
You do realise that you need to double press the lock button on the remote to initiate the shutdown of systems and to fully arm the alarm. Not doing this can lead to the battery flattening.
There are often sub codes following the general code you’ve given that are specific to make/model. You probably need to find someone with a code reader that can read the sub codes.

Post #391850 31st May 2020 7:11 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

After my battery has charged i will get the key out of the docking station and i will try locking it to see if that stops the electrical whining. Is the glow plug control module easy to replace? I know it located on the bulkhead near where the wiper motor is but not sure what has to be removed to get to it. Anyone know if having a faulty glow plug module will have knacker a glow plug or two again?

Post #391852 31st May 2020 8:08 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

Screenshot of code reader screen attached.[/img]

Post #391853 31st May 2020 8:21 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

Update: Battery charged up and started car just about. Dropped off at garage and waiting for further diagnosis. They still think faulty module causing all the issues.

Post #391907 2nd Jun 2020 2:23 pm
View user's profile Send private message View poster's gallery Reply with quote
oldgeezer



Member Since: 09 Apr 2011
Location: Wiltshire
Posts: 1302

United Kingdom 2013 Freelander 2 TD4 GS Manual Baltic Blue

the code could relate to a turbo charger waste-gate control, but this fault often flags if the battery voltage drops.
the whining could be the throttle body running.

its needs authentic diagnostic equipment and someone with good diagnostic ability, otherwise it starts getting guess works and and open book for parts. Jaguar x-type sport gone
Jaguar x-type 2.2d sport one of my best cars ever sadly gone
Freelander 2 GS auto 2008 most unreliable ever ! gladly gone
Freelander 2 GS manual 2013 only time will tell !

Post #391908 2nd Jun 2020 2:48 pm
View user's profile Send private message View poster's gallery Reply with quote
OMGHowMuch18



Member Since: 25 Jul 2018
Location: Loughborough
Posts: 14

United Kingdom 2011 Freelander 2 TD4 HSE Auto Barolo Black

Further update.. Picked up car after battery replacement and all seemed fine. But went out shopping ltoday and after a mile or so on dual carriageway eml came on and when plugged into odb reader it said p245a again. So it's had 4 new glow plugs and a new battery. What next? Any ideas? Think I will take it to a local land rover specialist. Any recommendations near Leicester?

Post #392007 4th Jun 2020 6:41 pm
View user's profile Send private message View poster's gallery Reply with quote
Post Reply  Back to top
Page 1 of 2 12>
All times are GMT + 1 Hour

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site