Ok. Super noob electrical question.

I have my piggy back fuse which will be used for a dashcam. I intend on wiring a cig socket onto this to then power the dashcam or anytjing else.

The fuse has a wire coming from it with some form of crimp. Do i simply put the bare power cable from the cig socket in and crimp.or should i put a ferrule on the cable and then insert that?


 FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

Just bare about 4mm of cable and push it in, then Crimp it with one of these.

https://www.tlc-direct.co.uk/Products/DR21...oCb1Hw_wcB p****d off with a Digital Keyboard Warrior

Perfect. Thabks. FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…