Having a problem with getting the rear seatbelts to locate when using Jane Indy Plus kids seats. The clip at the end of the buckle is slightly angled and is very near impossible when trying to locate male part into the female part. After having two kids this is sometimes a problem .
Beacause it is an isofix seatbelt the seat cannot move and is slightly too wide for the space available. I had the seats before buying the car and they fitted fine in my last car an XC90 and my wifes VW, never thought to check them in the demo car before deciding to buy. Dont really want tgo buy new seats but have seen a seat belt extender thingy on ebay, that might solve the problem.

Anyone else had the same problem and found a solution please advise.

I have not seen these seat belt extenders before, (until i just searched on eBay)

I had a similar problem on a FL-1 the rear seat belts where just long enough to fit round the rear facing child seat. But since it was a courtesy car i didn't look any further into it.

Do LR do anything? or any company like Motercare or M&P?

I would be weary buying something of such importance on eBay just in case they was knocked up copies from a far east sweatshop.

When it comes to safety of a loved one money doesn't matter. Former Mod/Member, with the most post & Chicken George Arch nemesis

I don't understand the problem very well ... I only found some difficulty in mounting

 www.fl2Italia.org

My seats are the older model, not sure if this is the problem or not. Have now bought one of the thingy's from ebay, it has a ford logo on it and appears very good quality. It also solves the problem perfectly.

Thanks