As the title says but how easy is it. I have a garmin bc30 camera coming that I would like to install soon. I'm not sure how to get the wire down to the back of the rear light area once I get pass the flexible rubber wire tubing. It seems to go into a boxed frame. Has anybody done this type of wire routing. Marto GS Sd4 2012

Hi Marto, I assume your cable run is from rear window frame through flexi tube and into the void between roof and liner,
this is what I did for my rear Thinkware camera, I then run cable down to rear nearside above wheelarch, to gain access remove lower trim in hatch opening (pulls straight up) tip rear side back seat forwards, then gently ease nearside rear side panel away starting from hatch end, followed by the upper rear quarter panel, this will enable the roof lining to be dropped on that corner (only one clip) reassemble is the reverse..... BUT make sure you have spare trim clips especially from both side panels.
Hope this helps

Dave DAVE.
I.A.M. F1rst Driver.
Gone 2003 Discovery TD5 Auto,
Gone 1986 Defender 90 Station Wagon
Gone 1984 Range Rover 3.5 Vogue Manual.
Gone 1970 Series 11A/3 SWB 3.5 V8 Hybrid
Gone 1964 Series 11A LWB Van
Gone 1966 Series 11A SWB Van
Gone 1964 Series 11A LWB Station Wagon,

Thanks for the info. All being well with the weather I'll be giving it ago next weekend. Marto GS Sd4 2012