Hi all

Recived my tow bar from Dan duckworths upon reading the picture instuctions it shows a picture of two drill holes snd im wondering if this means i need to drill into the lr2 Cant work it out and dont want to take the bumper off then find out i need metal drill bits

Click image to enlarge

Click image to enlarge

If I remember correctly it is the guide for cutting a slot in rear bumper.

Joe Fix it until it's broke !

Cheers Joe that kinda makes sense

Nice one for the help

Dan Freelander 57 plate XS Blue Auto

That is correct. The LR tow car requires a rear bumper valance cut. The advantage is the tow bar is as high as possible so as to not impinge too much on your departure angle (when used off-road). My Witter bar metalwork comes out below the bumper but makes a good battering ram for anyone following too close.  10MY (Sept 09) TD4 HSE Auto in Stornoway Grey (Now Gone)

08 FL2 TD4 SE Manual in Rimini Red (Now Gone)

Ths wont help the OP but might be of interest to other members; the Witter removable flange towbar (R41AQF) does not require the bumper to be removed or cut. Two holes need to be drilled behind the removable left bumper reflector ( to give access to 2 nuts) - though it can be done without drilling if you have small flexible hands, I'm informed.

Ive transfered the same Witter towbar onto each of my 3 Feelander 2s. The LR towbar installation always seemed unnecessarily complicated to me.

The R41AQF is currently going for a much reduced £196 at PJ Jones.
Witter now do a newer version which is more expensive. Jules